Simple to operate. Does not require programming. Uses trimpots and jumpers, which are factory set for most applications.
Motor horsepower selection jumper allows the drive to be used on a wide range of motor HP.
Diagnostic LEDs. PC board mounted LEDs for power on, drive status, and overload.
Run/Fault relay output contacts turn equipment on/off and signal stop mode if a fault has occurred.
Barrier terminal blocks facilitate wiring.
Jumper selection of drive output frequency increases the motor speed up to two times the rated RPM.
Motor overload (I2t) with RMS current limit prevents motor burnout and nuisance trips.
Electronic inrush current limit eliminates harmful inrush AC line current during startup.
Short Circuit. Shuts down the drive if a short circuit occurs at the motor (phase-to-phase).
Regeneration eliminates tripping due to bus overvoltage.
Overvoltage and undervoltage shuts down the drive if the AC line input voltage goes above or below the operating range.
On/Off Switch, Speed Pot, F-S-R Switch installed in front panel for easy access.
Built-in line filter for CE compliance.
cULus, RoHS, CE.
Extended 2-year system warranty when a Bodine gearmotor/motor and control are purchased together.
Application Information
Our PACESETTER? NEMA-1 / IP-40 AC motor speed control is designed to provide variable speed control for inverter duty rated, 230VAC, three-phase AC induction motors and gearmotors. The control is rated for continuous operation in an up to +40° C ambient and designed for stand-alone operation.
This control is ideal for variable-speed applications such as conveyors, packaging equipment, door and gate openers, and other industrial or commercial equipment.
網上亮照